|
The Trusscut Saw
is an automated machine, designed to simplify cutting of timber
components especially for trussed rafters in timber buildings.
It is an up
cutting single circular bladed saw operating with 3 CNC axis and powered
In-Feed system.
Software
Operation System
The controlling
software has been designed in response to customer feed back, it requires
very little operator training even to people who do not use computers. It
will interface with any nail plate system software programs.
Data
Input
The saw can be linked
via a network to the truss design PC and accept cutting data directly
from the compiled job files. Alternatively data can be transferred from
USB memory stick via the machines USB Port
which is protected by an industrial dust proof cover, or data can be
input manually via the large touch screen from a cutting sheet.
CNC
Control
There are 3 CNC
controlled axis, Angle, Centreline and Length.
When the saw is
operating in automatic mode, the angle and centre line are immediately
set to cut the first component listed on the imported job file.
The length will
move to its positions at a touch of a button, time taken to travel 6
metres is 8 seconds. This time will be less if the overall length is less
than 6 metres.
Feed
System
The robust In-Feed
and Out-Feed systems are both fitted with two timber clamps. One of the In-feed and
both of the Out-feed clamps fully retract when in the off position this
makes the loading and off loading operation easier.
All the clamp
shafts, clamp guide rods and pneumatic cylinder rods are made of
stainless steel and the guide bushes are Teflon lined. This eliminates
any lubrication or rust problems and renders them maintenance free.
Safety
The machine has
been designed to conform with the European safety standards and has been
typed tested and certified, every machine bears the "CE" mark.
Environment
Control
Dust extraction
outlets are fitted for easy connection to your dust extraction system.
Maintenance
The minimum of
routine maintenance is required.
|
